Marine Design Plug-in for Rhino

+1 (410) 604-8000 | Support: Ext. 3 | Sales: Ext. 4 | Email Us

Weight and Cost

 

The success of any design hinges on its weight and center of gravity (CG). These parameters are fundamental to stability, speed, payload capacity, seakeeping performance, etc. Weight and CG tracking therefore must be a fundamental part of any design process.

Cost is another critical factor in the success of a design, and good engineering practice calls for cost considerations to be closely tied to the design process.

Orca3D’s Weight/Cost Tracking module adds value to your Rhino model by assigning weight and cost parameters to the objects in the model, and summarizing and presenting the data.

For example, a surface that represents a portion of the hull can be assigned a weight per unit area, and as that surface is modified, the total weight and center of gravity updates automatically. The cost parameter is broken down into material cost and labor cost, and can also be assigned on a per unit area basis. Similarly, curves can be assigned values on a per unit length basis, and solids can have either per unit area or per unit volume values. Also, curves, surfaces, and solids, as well as point objects, can be assigned an absolute value for weight and/or cost, that will not change as the object is modified.

To simplify the process of assigning weight and cost values to your objects, Orca3D includes the ability to create a library of stock materials, and you can assign a stock material to the objects in your model. For example, you might create “5 mm steel plate,” with a unit weight per square meter, a material cost per square meter, and a labor/fabrication cost per square meter.

weight1

weight2

Andy Mcloughlin c-fury Limited
Our current yacht tender was designed, developed, and tuned with Rhino and Orca3D. The boat would never have seen the light of day if it was not for Rhino and in particular Orca3D for weight/balance design evaluation and engineering - an invaluable tool.