OrcaMove Crash

[swolczko]

I am using the newest release of Orca3d (with Rhino 4) and I have had two instances of the entire application closing out after I try to perform an 'OrcaMove' operation.  It occurred once after simply trying to adjust a single Cartesian coordinate for a point, and again while trying to adjust a relative polar coordinate.  There was no error message associated.

Any ideas?  Fair enough if not--I just wanted to pass the instance along to the powers that be.

Cheers.

[Admin]

Stefan:

It's difficult to diagnose without more details. There isn't a known issue that I can point to.

Is it possible to send the Rhino model to support@orca3d.com, with a bit more detail on the steps up to the crash? If so, we can try to reproduce it and fix the problem.

Thanks,
Bruce